Ezcad software settings and install on new computer procedure

Ezcad opertion Interface simple guide manual
Ezcad Instructions – Ezcad opertion Interface simple guide manual
July 15, 2020
mini uv laser marking machine
UV Laser Marker Advantage and Disadvantage
October 7, 2020
Show all

Ezcad software settings and install on new computer procedure

ezcad software settings

Ezcad software settings and install on new computer procedure

ezcad software settings

Please notice before you install the software on new PC,please keep the USB cable connect well between computer and laser marking machine,also it is better to open the laser button
1.Copying the Ezcad software from our U disk,then connecting your personal laptop to our control cabinet,then open your laptop ,select “computer”,click the right button of the mouse,choose the “Properties”,which the following picture indicating you
2.After finishing the first step, you will get the below picture,choose the “Device Manager” Button,then you will find the “Unknown device” in the interface,double click the mouse
3.After finishing the 2 steps ,you will get the following interface,click the “Driver button”
4.After click the “Driver” button,please select the “Update Driver” to continue
5.In this step ,you will get the following interface,select the “Browse my computer for driver software
6.Then, choose the “Browse”,You will open the control board drive,then select the correct one,and click the “OK” button
7.After you click “OK” button,you will get the below picture,choose “install” button to continue
8.After all above step has been finished, you will install the control card driver successfully

Comments are closed.

keywords:metal laser engraving machine metal laser engraving machine